Do you know all the possibilities of ERKO crimping tools? Discover the wide range of hand presses and other crimping tools in our offer. Without these tools it wouldn’t be possible to perform the correct crimping of cable terminals. Find out about all the possibilities of our crimping tools.
Hand press A 11-6 is designed for crimping ring terminals type KOA, spade terminals type KNA and pin terminals without insulation type KWA. With the help of this tool you can also crimp tubular connectors type KLA, and tubular terminals type KCS of 2,5 ÷ 6 mm2. Even using the minimal force you can easily perform the crimping of cable terminals and connectors. In order to adjust the clamping force this hand press uses the eccentricity.
If you are looking for a hand press for ring terminals with and without insulation type KOA and KOE? You should choose the hand press AE 22-05. It is also used for crimping spade terminals both with and without insulation type KNA and KNE. The wire cross-section range is from 0,1 ÷ 0,5 mm2.
Choose hand press RA 16, that can be used for ring terminals and connectors type KOA, spade terminals and connectors type KNA, and pin terminals type KWA without insulation. The wire cross-section ranges from 0,5 ÷ 16 mm2.
For crimping receptacles and tabs without insulation it is recommended to use the hand press S 33-1, and hand press S 11-6. In case of the firs tool the wire cross-section ranges from 0,14 ÷ 1,0 mm2. When it comes to the hand press S 11-6, the cross-section is from 0,5 ÷ 6 mm2. Both hand presses can be used only for cable terminals made according to DIN 46247 and 46248.
If you need a hand press for claw terminals type KOP and KNP? You should choose hand press S 44-2 with the wire cross-section rage of 0,5 ÷ 2,5 mm2. The ratcheting mechanism makes it possible to crimp even using minimal force.
Discover all of the possibilities of ERKO crimping tools ! We invite you to learn more about our offer! Only the best tools will allow you to perform crimping on the highest level. Read our catalogue ! Only with ERKO tools you can be sure that the crimping process is done correctly. Welcome!