In the offer of ERKO crimping tools you can find not only hand presses, battery powered presses, hydraulic heads, but also pneumatic presses, crimpers and seal presses.
In our catalog you can find two types of pneumatic crimping tools :
– PP 8
– PP 19.
The first one is designed for crimping of ring terminals, spade terminals, pin terminals, receptacles and tabs , cable end-sleeves and tubular terminals without insulation and with insulation. The wire cross section ranges from 0,5 ÷ 25 mm2. It is worth noting that it works with PPH 11, PPH 12 and PPH 13 heads. It is also suitable for cutting Cu multi-strand wires with PVC insulation up to 25 mm2. It is a very efficient tool, with the speed of 50 cycles/min. It is powered by compressed air of 0,6 ÷ 0,8 MPa. In addition, it has a crimping control system.
The speed of cycles in case of PP 19 pneumatic press is 25/min, and the efficiency can change depending on the operator . In case of both PP 8 and PP 19 pneumatic presses it is possible to buy optional steering system, that allows you to control if the cycle was done correctly.
The PK 95 crimper is adjusted for AL and AFL overhead line connectors, with SK dies. The wire cross section in case of this tool is 16 ÷ 95 mm2. Pay attention to the type of die and the corresponding cross section of the AL and AFL connectors.
Type of die | AL connectors cross section | AFL connectors cross section | |
---|---|---|---|
SK 16 | 16 | – | |
SK 25 | 25 | 16 | |
SK 35 | 35 | 25 | |
SK 50 | 50 | 35 | |
SK 70 | 70 | 50 | |
SK 90 | 90 | 70 |
The P1 seal press is made of plastic or lead . In standard version it is sold without crimping dies ,but you can buy the separately.
In our offer you can also find different types of hand presses that can be used for crimping of different types of cable terminals and cable connectors. Only in our catalog you can find the best crimping tools that guarantee that the crimping process is the most efficient.
Welcome!
Crimping tools in E-catalog. |